Digital Monitoring Products XR20 User's Guide download pdf (Page 28)

24 XR20 User’s Guide User Menu

System Test

User Code Level: Master or Standard.

Function: System Test is used to test the battery, alarm bell

or siren, and central station communi cation. The System Test

function begins automatically as soon as you select it.

Using the System Test Function

1. Access the User Menu.

2. Press the COMMAND key until SYSTEM TEST? displays.

3. Press any Select key. The system test begins automatically

and the keypad displays:

1) BELL SOUNDING during a two second bell test, then:

2) BATTERY - OKAY or BATTERY - TRBL to indicate the

battery condition, then:

3) TRANSMIT TEST * and ATTEMPT NO : 1 during the

transmit test, then:

4) TRANSMIT OKAY or TRANSMIT FAILED to show the

transmit test results, then:

5) TEST END to indicate the System Test is complete.

6) Press the Back Arrow key to end the system test.

* The transmit test does not occur on local systems.

Testing your system burglary protection: The System Test function

should be part of your weekly testing and should be followed by

placing the burglary devices in Zone Monitor mode. This allows

you to open and then close each protected door and window while

listeningforthekeypadtobeepconrmingitsoperation.SeeZone

Monitor.

Using the Zone Monitor Function

1. Access the User Menu.

2. Press the COMMAND key until ZONE MONITOR? displays.

3. Press any Select key.

The keypad displays PERIM ALL NBR.

4. Select PERIM to place all disarmed perimeter zones into

Zone Monitor.

4a. The keypad displays PERIM? ADD RMV.

4b. Select ADD to add all perimeter zones to Zone Monitor.

4c. Select RMV to remove all perimeter zones.

5. Select ALL to place all disarmed zones into Zone Monitor.

5a. The keypad displays ALL? ADD RMV.

5b. Select ADD to add all disarmed zones to Zone Monitor.

5c. Select RMV to remove all disarmed zones.

6. Select NBR to enter a specic zone number for zone

monitor.

7. If NBR is selected, the keypad displays ZONE : - ADD RMV.

7a. Enter any zone number and select ADD to add this

zone.

7b. Enter any zone number and select RMV to remove the

zone.

8. The zone number automatically disappears and a new zone

number can then be entered. See step 7.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 51 52

Comments to this Manuals

No comments

Digital Monitoring Products XR20 User's Guide Page 28

Comments to this Manuals

Related products and manuals for Security access control systems Digital Monitoring Products XR20