Digital Monitoring Products XR20 User's Guide download pdf (Page 16)

12 XR20 User’s Guide Arming and Disarming

Exit Delay: The keypad then displays the exit delay time as it

counts down. Your system may be pre-programmed at installation

to beep the exit delay tone at eight-second intervals until the

last 10 seconds when the keypad beeps at three-second intervals.

After exiting the building, if you re-enter during the countdown the

exit countdown restarts, allowing additional time to then disarm

or again exit the building during the countdown. This restart

can occur only one time. When the exit delay time ex pires, all

disarmed zones are armed. If your system uses a keyswitch to arm

an area, the exit delay time does NOT count down on the keypad

display.

When you arm both the Perimeter and Interior to leave the building

but then you do not exit by the time the exit delay ends, the

system automatically arms but the interior area(s) will remain

disarmed because you have not exited.

Should you exit the building and the door does not close properly,

your system may be programmed so that when the exit delay

countdown ends, then the entry delay starts and the bell will sound

to alert you to the situation. Enter your user code to stop the bell

and disarm the system. Rearm the system, exit the building, and

make sure the door is securely closed.

DIALING . . . Message: If your system is monitored, it may be

programmed to wait for the arming report to be sent to the central

station before displaying the armed mes sage. (See Arming Report

below.)Thisveriesyourphonelinesareworkingproperly.While

the system waits, the display reads DIALING.... If the report is

received, the keypad buzzes for one second and displays the armed

message. If the report is not received, the keypad displays LOCAL

ALARM ONLY before displaying the armed message.

Arming Report: Your system may be pre-programmed at installation

to send arming or zone bypass reports to a central station.

Key Fob Arming

Press the key fob button programmed for Arming or Toggle (Arm/

Disarm) button. A Red LED two-second acknowledgement indicates

All System On. A Green/Red two-second acknowledgement

indicates System On with some areas armed.

Key Fob Disarming

Press the key fob button programmed for Disarming or Toggle

(Arm/Disarm) button. A Green LED two-second acknowledgement

indicates All System Off.

Note: Disarming authority needs to be enabled for the User Code

assigned to the Key Fob. Refer to Adding User Codes later in this

document.

Area System Arming

Area Assignment: Your security system is programmed into separate

areas. The number of areas and their names are listed in the back

of this guide.

Arming or Disarming: You can arm and disarm all areas at one time or

each area individually. You can only arm or disarm areas authorized

for your user code.

All or Selective Arming: After entering your user code, the system

allows you to arm either all of the areas to which you have access

or one or more selected areas. If you choose to arm all areas, the

system begins verifying that all zones in those areas are in a good

condition. If you choose to arm selected areas, the system prompts

you to choose the areas you want to arm.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 51 52

Comments to this Manuals

No comments

Digital Monitoring Products XR20 User's Guide Page 16

Comments to this Manuals

Related products and manuals for Security access control systems Digital Monitoring Products XR20