Digital Monitoring Products XR20 User's Guide download pdf (Page 21)

Arming and Disarming XR20 User’s Guide 17

Arming a Home/Away System

1. Enter your user code. The keypad displays HOME AWAY or

HOME SLEEP AWAY (you may have three areas).

2. Select HOME to arm the Perimeter only.

3. Select SLEEP to arm the Perimeter and Interior.

4. Select AWAY to arm the Perimeter, Interior, and Bedroom.

5. The keypad displays zones that have been bypassed prior to

arming and zones that are in a faulted condition. No action

is required by you.

6. At this point you can force arm or bypass any faulted zones.

A zone that is force armed is restored into the system if it

later returns to normal. A zone that is bypassed remains

bypassed until the system is disarmed. See steps 6a through

6d.

6a. If a problem exists on any zones, the zone name and

problem display followed by: OKAY BYPASS STOP.

6b. Select OKAY to force arm the zone(s) before arming.

6c. Select BYPASS to bypass the zone(s) before arming.

6d. Select STOP to stop the system from arming. Correct

the zone problem(s) and return to step 1.

7. The keypad displays HOME MODE ON if you selected HOME,

or SLEEP MODE ON if you selected SLEEP, or ALL SYSTEM

ON if you selected AWAY.

8. The keypad next displays EXIT: ## INSTNT and begins to

count down the number of seconds remaining for you to exit.

When the delay expires, all zones are armed.

9. You can select INSTNT while EXIT: ## INSTNT displays to

immediately arm all zones and make them instant. The

keypad displays INSTANT. When you select INSTANT, any

entry/exit zone that trips immediately activates an alarm

and the exit delay countdown immediately stops.

10. When the system is armed, the keypad displays HOME MODE

ON for Perimeter arming, SLEEP MODE ON for Perimeter and

Interior arming, and ALL SYSTEM ON for all areas armed.

Home/Away System Disarming

Disarming: While the system is armed, you can only enter the

premises through an entry/exit delay door without causing an

alarm. After opening the door, the keypad sounds a prewarn tone

to remind you to disarm the system. You must disarm the system

before the prewarn tone expires or an alarm on the door occurs.

During the prewarn tone, the keypad displays ENTER CODE:. Enter

your code to disarm the system.

Note: Your system may be pre-programmed at installation to silence

thetoneassoonastherstusercodedigitkeyispressed.Ifavalid

user code is not entered within 5 seconds or an invalid user code is

entered, the prewarn tone begins sounding again.

Alarm Display: After disarming, the keypad dis plays any zones

that tripped or any communication problems that occurred dur ing

the armed period. All burglary zones are then dis armed and any

by passed zones automatically reset.

Disarmed Message: The keypad displays ALL SYSTEM OFF after the

system disarms.

Central Sta tion Report: Your system may be pre-programmed at

installation to send a report of the system disarming to the central

sta tion.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 51 52

Comments to this Manuals

No comments

Digital Monitoring Products XR20 User's Guide Page 21

Comments to this Manuals

Related products and manuals for Security access control systems Digital Monitoring Products XR20