Digital Monitoring Products XR20 User's Guide download pdf (Page 20)

16 XR20 User’s Guide Arming and Disarming

Disarmed Message: The keypad displays ALL SYSTEM OFF after the

system disarms.

Central Sta tion Report: Your system may be pre-programmed at

installation to send a report of the system disarming to the central

sta tion.

Disarming an All/Perimeter System

1. During the entry delay time, the keypad displays ENTER

CODE:. Enter your user code.

2. The keypad displays any zones that went into alarm and any

communication problems that occurred during the armed

period.

3. The keypad next displays ALL SYSTEM OFFtoconrmthe

system is disarmed.

Disarming During an Alarm

1. While the alarm bell or siren sounds, enter your user code to

silence the alarm.

For a burglary alarm, the keypad displays

CANCEL VERIFY.

This allows you to investigate the alarm prior to disarming

the system. This display remains on the keypad until a

selection is made, the Back Arrow is pressed, or the internal

system bell cutoff timer expires.

2. If a valid alarm has not occurred, Select CANCEL to disarm

the system and cancel the alarm.

The keypad displays ALARM CANCELLED then ALL SYSTEM

OFFtoconrmthesystemisdisarmed.

If the alarm is valid, select VERIFY to send a verify message

to the Central Station.

Home/Away System Arming

Area Assignment: Your security system is divided into two or three

separate areas. Motion detectors, inside doors, and other interior

devices are assigned to an Interior and possibly Bedroom area while

windows and exterior doors, are assigned to a Perimeter area.

Arming the system: When arming a Home/Away system, the

keypad displays HOME AWAY or HOME SLEEP AWAY. If you

select AWAY, you arm all areas of the system. You want to arm all

areas when leaving with nobody staying inside.

Selecting HOME arms only the system Perimeter. Perimeter arming

is for when you are staying inside but want the comfort of knowing

the exterior doors and windows are armed.

Selecting SLEEP arms the Perimeter and Interior devices but leaves

devices near bedrooms and other nighttime areas off.

System Ready/System Not Ready Keypad Displays

When all system zones are in a normal condition and can be armed

without bypassing, the keypad displays SYSTEM READY. If there

are one or more zones that are not in a normal condition, the

keypad displays SYSTEM NOT READY. Pressing any Select key

during this display shows the bad zone name.

Home/Sleep/Away Shortcut Key Arming

Arm Home — Press 3 for 2 seconds to arm the perimeter.

Arm Sleep — Press 7 for 2 seconds to arm the perimeter and

interior areas and leave the bedroom area off.

Arm Away — Press 1 for 2 seconds.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 51 52

Comments to this Manuals

No comments

Digital Monitoring Products XR20 User's Guide Page 20

Comments to this Manuals

Related products and manuals for Security access control systems Digital Monitoring Products XR20