Digital Monitoring Products XR20 User's Guide Page 12
- Page / 52
- Table of contents
- BOOKMARKS
Rated. / 5. Based on customer reviews
8 XR20 User’s Guide Introduction
ALARM NOT SENT
The alarm signal was aborted and was not sent to the central
station because a user code was entered to disarm the system
before the alarm signal was sent to the central station. Also, your
system may be pre-programmed at installation to send an Abort
signal to the Central Station. Refer to the Introduction section of
this guide.
ALARM VERIFIED
Avalidburglaralarmhasoccurredandhasbeenmanuallyveried
by the user. The alarm system also transmits a VERIFY message to
the Central Station.
ALARM CANCELLED
An Alarm signal just sent to the central station was cancelled
because a user code was entered after the alarm was sent. Also,
an Alarm Cancel signal is sent to the Central Station.
ENTER CODE
The system requires you to enter a personal user code. User codes
can be used for turning your system on (arming), turning your
system off (disarming), and other system options.
As you enter your user code, the keypad display shows an asterisk
(*) in place of each digit pressed. This prevents others from seeing
your user code on the display as you enter it.
TRY AGAIN
The user code you entered is not recognized by the system. Check
the user code and try again.
INVALID CODE
The user code you entered is considered invalid by the system.
Special Wireless Displays
Your system may use wireless transmitters to send alarm and
trouble information from the protection devices to the panel.
Wireless systems have a few unique keypad displays.
BACK DOOR -LOBAT - (Low Battery) The battery in a wireless
transmitter is low. (BACK DOOR is used as an example only.)
BACK DOOR -MISNG - (Missing) The panel is not receiving the
wireless transmitter periodic test report.
WIRELESS -TRBL - (Trouble) Some part of your wireless system is
operating improperly. Call the service department for assistance.
WIRELESS RECEIVER JAMMED -ALARM - Your system may be
programmed for wireless interference detection and, if displayed,
your wireless receiver has detected an interfering signal while the
system is armed.
WIRELESS RECEIVER JAMMED -TRBL - (Trouble) Your system may be
programmed for wireless interference detection and, if displayed,
your wireless receiver has detected an interfering signal while the
system is disarmed.
Special Keypad Displays
As you use your system, you may occasionally see a keypad display
that asks you to enter a user code or describes a condition on the
system. Below are some examples of the displays you may see.
ALARM
A24-hourzone,suchasareorpaniczone,oranarmedburglary
zone is faulted. Your system may sound bells or sirens.
- User’s Guide 1
- Silencing an Alarm 2
- Security Command 3
- User’s Guide 3
- Section Page 4
- Introduction 5
- Emergency Evacuation Plans 6
- ABC PRINTING 7
- FRI 2:51 AM 7
- (<—) key 8
- Police Emergency Fire 9
- Touch Select Areas 9
- Keypad User Options 10
- Special Keypad Tones 10
- Special Wireless Displays 12
- Special Keypad Displays 12
- Arming and Disarming 15
- Key Fob Arming 16
- Key Fob Disarming 16
- Area System Arming 16
- Area System Disarming 17
- All/Perimeter System Arming 18
- Home/Away System Arming 20
- Home/Away System Disarming 21
- 1 2 3 4 22
- 9 0 CMD 22
- 5 6 7 8 22
- User Menu 24
- User Check-in 25
- Zone Activity Check 25
- Sensor Reset 26
- Outputs On Off 26
- Bypass Zones 27
- Zone Monitor 27
- System Test 28
- User Codes 29
- Ambush Code 31
- Schedules 32
- Permanent Schedules 32
- Extending Schedules 33
- Date and Time 33
- Request Service? 34
- Display Events 34
- System Setup 35
- Appendix A 38
- Zone Event Displays 39
- User Check-in Event Displays 39
- Supervisory Event Displays 40
- System Monitor Event Displays 40
- Appendix B 41
- Easy Entry™ User’s Guide 42
- ABC SECURITY 43
- ENTER CODE: – 43
- Appendix D 44
- Events - ALARM or TROUBLE 44
- Index XR20 User’s Guide 43 47
- 44 XR20 User’s Guide Index 48
- Area Names 49
- Quick Reference Wallet Cards 49
- Numeric Pager Display 50
- LT-0303 1.01 52
Related products and manuals for Security access control systems Digital Monitoring Products XR20
Security access control systems Digital Monitoring Products Graphic Touchscreen User Manual
(25 pages)
(25 pages)
Security access control systems Digital Monitoring Products Canadian XR100 Installation Guide
(46 pages)
(46 pages)
Security access control systems Digital Monitoring Products Canadian XR100 Instruction Manual
(78 pages)
(78 pages)
Security access control systems Digital Monitoring Products Graphic Touchscreen User Manual
(4 pages)
(4 pages)
© 2020, manymanuals.com. All rights reserved. | 0.519 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals