Digital Monitoring Products XR20 Installation Guide download pdf (Page 20)

XRSuper6/XR20/XR40 Programming Guide

Digital Monitoring Products www.dmpnet.com 2500 N. Partnership Boulevard Springfield, MO 65803

6.9 RESET SWINGER BYPASS

When YES is selected, a swinger bypassed zone is reset if it remains in a normal

condition for one hour after being bypassed. A report of the automatic reset is sent

to the receiver if Bypass Reports has been selected as YES. See the BYPASS REPORTS

section.

6.10 TELEPHONE ACCESS

YES allows the use of standard DTMF telephones to arm and disarm and check the

armed status of the XRSuper6/XR20/XR40 panel. PHON ACC must be YES for

operation with the 895 Voice Module. Refer to the XRSuper6 (LT-0622), XR20 (LT-

0303) or XR40 (LT-0494) User's Guide for complete information.

6.11 ZONE ACTIVITY HOURS

This allows you to select the number of hours a countdown timer is set when the

system is completely armed and burglary zones are disarmed, or after a panel reset

and burglary zones are disarmed. The range for the countdown timer is 0 to 9. The

timer is reset each time a disarmed burglary zone trips (open or short). When an

open/close schedule is programmed, the countdown timer is only active during the

scheduled open period. If disarmed burglary zones exist when the schedule is used,

then the countdown timer resets at the schedule opening time. The SUPV/TRBL

receiver option must be selected in Receiver 1 or 2 programming for the message to

be sent.

6.12 ARM ACTIVITY DAYS

This allows you to select the number of days a countdown timer is set for area

arming and disarming activity. The range for the countdown timer is 00 to 99. When

the timer counts down to zero because of no area arming or disarming activity, the

panel sends a "XX Days No Arming/Disarming" message to the receiver at 10:00 am.

The SUPV/TRBL receiver option must be selected in Receiver 1 or 2 programming for

the message to be sent. Each time an area is armed or disarmed, the timer is

restarted. When the countdown timer expires because of no area arming or

disarming activity, and a message is sent, the timer does not restart until a panel

reset occurs or an area is armed or disarmed.

SYSTEM OPTIONS

ARM ACTY DAYS:

ZN ACTY HRS:

PHON ACC NO

RST SBYP YES

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 37 38

No comments

Digital Monitoring Products XR20 Installation Guide Page 20