Digital Monitoring Products XR20 Installation Guide download pdf (Page 9)

XRSuper6/XR20/XR40 Programming Guide Digital Monitoring Products

inTroduCTion

Introduction

1.1 Before You Begin

Before starting to program, we recommend you read through the contents of this manual. The

information in this document allows you to quickly learn the programming options and operational

capabilities of the XRSuper6/XR20/XR40 panel.

After this Introduction, the remaining sections describe the functions of each programming menu items

along with their available options. The XRSuper6/XR20/XR40 contains all of its programming information

in an on-board processor and does not require an external programmer.

In addition to this manual, you should also be familiar with the following XRSuper6/XR20/XR40

documents:

• XRSuper6/XR20/XR40 Installation Guide (LT-0624)

• XRSuper6 User’s Guide (LT-0622)

• XR20 User’s Guide (LT-0303)

• XR40 User’s Guide (LT-0494)

Programming Information Sheet

Included with each XRSuper6/XR20/XR40 panel is the Programming Information Sheet. This sheet lists the

various keypad prompts and available options for programming the panel. Before starting, completely ll

out the sheet with the programming options you intend to enter into the panel.

Having completed programming sheets available while entering data helps to prevent errors and can

shorten the length of time you spend programming. Completed sheets also provide you with an accurate

account of the panel’s program you can keep on le for future system service or expansion.

The remainder of the Introduction explains starting and ending a programming session.

1.2 Getting Started

Ground Yourself Before Handling the Panel! Touch any grounded metal, such as the enclosure, before

touching the panel to discharge static.

Remove All Power From the Panel! Remove all AC and Battery power from the panel before installing or

connecting any modules, cards, or wires to the panel.

The XRSuper6/XR20/XR40 panel must be completely installed before you begin programming. Make sure

the panel is properly grounded, and the AC and battery wires are correctly installed.

Initializing the Panel

When programming an XRSuper6/XR20/XR40 panel for the rst time or rewriting the entire program of an

existing XRSuper6/XR20/XR40, use the Initialization function described in section 2. Initializing clears

the panel’s memory of any old data and sets the highest numbered user number to user code 99.

Program from any Keypad Address

You can program the XRSuper6/XR20/XR40 panel from any keypad connected to the keypad data bus. See

the XRSuper6/XR20/XR40 Installation Guide (LT-0624) for keypad addressing and installation information.

Accessing the Programmer

To access the programmer function of the XRSuper6/XR20/XR40:

1. Place a slotted screwdriver across the two J16 reset jumpers for two seconds.

2. Remove the screwdriver.

3. Enter the code 6653 (PROG) into the keypad.

4. Enter your Lockout Code.

5. The keypad displays: PROGRAMMER.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 51 52

Comments to this Manuals

No comments

Digital Monitoring Products XR20 Installation Guide Page 9

Comments to this Manuals

Related products and manuals for Security access control systems Digital Monitoring Products XR20