Digital Monitoring Products XR20 Installation Guide download pdf (Page 10)

Digital Monitoring Products XRSuper6/XR20/XR40 Programming Guide

inTroduCTion

1.3 Programming Menu

You are now ready to start programming the XRSuper6/XR20/XR40 panel. Pressing the COMMAND key

scrolls you through the 12 programming menu items listed in below.

Note: The 692 Security Command keypad is not suitable for panel programming.

Menu Item Section in This Manual Menu Item Section in This Manual

Initialization 2 Output Options 8

Communication 3 Output Information 9

Remote Options 4 Area Information 10

System Reports 5 Zone Information 11

System Options 6

Stop

Bell Options 7 Set Lockout Code 13

To select a section for programming, press any Select key when the name of that section displays on the

keypad. The detailed instructions for each programming step are found in sections 2 to 13 of this manual.

1.4 Programmer Lockout Codes

Although the XRSuper6/XR20/XR40 panels allow you to access Programmer mode without a lockout code,

we recommend you program one to restrict programming access to authorized individuals only. You can

do this by using SET LOCKOUT CODE at the end of the programming menu.

Installing a lockout code

1. After entering the Programmer menu, the keypad displays PROGRAMMER. Press the COMMAND key

until SET LOCKOUT CODE is displayed (after STOP).

2. Press any Select key. At the ENTER CODE: - display, enter a 1- to 5-digit programmer lockout code.

Press COMMAND.

3. The displays shows ENTER AGAIN. Enter the same lockout code again and press COMMAND. The

display shows CODE CHANGED. The new code number must now be entered before the Programmer

menu can be accessed.

The lockout code should be written down and kept in a secure place with access limited to authorized

persons only.

Lost Lockout Code requires factory reset: If you lose or forget the lockout code, the panel must be sent

back to the factory to be reset. There is no eld option for gaining access to the panel without a valid

lockout code.

1.5 Reset Timeout

The XRSuper6/XR20/XR40 has a feature that requires you to enter the Programmer within 30 minutes of

resetting the panel. After 30 minutes, if you attempt to program by entering the 6653 (PROG) code, the

keypad displays: RESET PANEL. You must reset the panel and enter the program code within the next 30

minutes.

If you are already in the Programmer and do not press any keys on the programming keypad for 30

minutes, the panel terminates programming. All data entered up to that point is saved in the panel’s

memory.

Using the STOP function disarms all areas: To exit the panel’s Programmer you must use the Stop

function. The STOP option is the second to the last option in programming. The Stop function disarms all

areas and clears the panel’s Status List.

The programming session is then terminated and the keypad returns to the Status List.

1.6 Power Up

When the SIA CP-01 option in System Options is set to Yes, for 60 seconds after power up or after resetting

the panel, any zone transitions are not recognized. Normal zone processing resumes at the end of the

60 seconds.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 51 52

Comments to this Manuals

No comments

Digital Monitoring Products XR20 Installation Guide Page 10

Comments to this Manuals

Related products and manuals for Security access control systems Digital Monitoring Products XR20