Digital Monitoring Products XR20 Installation Guide download pdf (Page 18)

Digital Monitoring Products XRSuper6/XR20/XR40 Installation Guide

InstallatIon

Annunciator Outputs

12.1 Description

The four annunciator outputs can be programmed to indicate the activity of the panel’s zones or conditions

occurring on the system. Annunciator outputs do not provide a voltage but instead switch-to-ground voltage

from another source. The outputs can respond to any of the conditions listed below:

1) Activation by zone condition: Steady, Pulse, Momentary, or Follower 7) Exit and Entry timers

2) Manually from the keypad 8) System Ready

3) Communication failure 9) Ground start activation

4) Armed area annunciation 10) Cellular Backup

5) Fire Alarm or Fire Trouble 11) Late to Close

6) Ambush alarm

12.2 Harness Wiring

The open collector outputs are accessible by installing the DMP 300 Harness on the 4-pin header labeled

J11. The output locations are shown below. For UL applications, devices connected to the outputs must be

located within the same room as the panel.

Output Color Wire Output Color Wire

1 Red 1 3 Green 3

2 Yellow 2 4 Black 4

12.3 Model 860 Relay Module

Connect a Model 860 Relay Module to the panel to provide relays for the annunciator outputs that can be

used for electrical isolation between the alarm panel and other systems or for switching voltage to control

various functions. The module includes one relay and provides three additional sockets for expansion of up

to four relays. Power is supplied to the relay coils from the panel keypad bus. The 860 mounts inside the

panel enclosure using the 3-hole mounting conguration. Plastic standoffs are provided with the module for

ease of installation. A 4-wire harness is also provided that connects the Model 860 to the DMP panel.

Relay Contact Rating: 1 Amp at 30 VDC

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 30 31

No comments

Digital Monitoring Products XR20 Installation Guide Page 18